You never know these days,
https://www.outboardglobalstore.com/oxe-diesel
ABOUT US
Welcome to Outboard Global Store ,
I laugh every time I see this.
I am designing a 2021 Switzer wing clone for Mercury 150 4 strokes.
The problem is, 20 " legs are only RH rotation and 2;1 gears. You
I have always been fortunate enough to have a cottage, now a home, on the water. It makes boating much more accessible. For example, yesterday when
Last Post By: FUJIMO Today, 08:02 PMHi,
Bought an Exocet 23 (piranha hull with phantom deck) and I put a 300 R, 1.75 TM, on it (not an SM, no hydraulic jackplate on it).
Original 23' outboard, 8' Beam, 2018 Mercury 400 on stainless marine setback.
20" lower with fat shaft
Boat has small cabin,
Need a pair of 280 stock heads. 150 psi or less.
Thank you
Was thinking I could run these I have run worse in the past. I don’t want to shave these further they are 34cc which is what I want. I do have some 38’s
Last Post By: LakeFever Today, 05:16 PMwhat triggers the temp alarm to go off ? i have a cylinder temp sensor, wire runs externally up to dash gauge, in harness have a tan and tan/blue hanging
Last Post By: KIRCHNER Today, 04:27 PMhttps://www.speedmastermarine.com/pr...0-outboard-ecu
Is there someone here with deep pockets ready to try this? Or is this
I read somewhere that the tension on the belt should be 70 inch - lbs. What is the correct way to check... set the torque wrench to 70 inch - lbs. then
Last Post By: 4Speed Today, 03:48 PMCurrently purchasing a 1990 135 horse Mercury v-6 that supposedly has low compression in hole number 6, owner says cylinder may be scuffed. Is it possible
Last Post By: tlwjkw Today, 03:42 PMTrying to find out the exact material used on the slide section on CMC jackplate . Its a grayish plastic materail around 3/32 thick . I cant recall the
Last Post By: KIRCHNER Today, 02:47 PMhttps://www.visitpavia.com/en/event/...-2nd-june-2024
Last Post By: scott reierson Today, 01:04 PM
A New outboard motor manufacture
Thread Starter: CUDAhttps://www.caudwellmarine.com/
Last Post By: CUDA Today, 10:47 PM