I have 97 225 Carbed OB, 20" leg, Bobs Cone, has Merc Mirage Plus 25" I believe, its on a 21 Challenger (knock off), over a foot of setback,
Last Post By: Aaronhl Today, 10:13 AMI have twin 300 promaxs 26ft American offshore.. 25ft talon bottom.. 18inch box's and 1.62 sportmasters even with bottom of sponsons..have 3/16 toe out
Last Post By: SUNKIST Today, 09:56 AMThrough a visor camera.
Historic Mercury XS1500 Tower of Power 6 Cylinder Inline - 150 Horsepower -Top End of Motor is in pieces but all there, complete short shaft with low
Last Post By: 86vintage Today, 09:28 AMI hope everyone can see thru suckerberg. Heres some info that may be useful. > https://apnews.com/article/meta-ai-i...7b3756deb5587b
Last Post By: NICE PAIR Today, 08:22 AM
had this for a backup when ia had a 115hp i never used it. Its complete. Spins freely i see neutral
I have always been fortunate enough to have a cottage, now a home, on the water. It makes boating much more accessible. For example, yesterday when
Last Post By: JBS Today, 08:07 AMFigured I would start a project thread...
1991 Gambler Intimdator Dale Earnhardt edition
1998 Merc 200 efi
Project started
make me an offer if anyone needs it.
Clean set of carbs with the enrichment nipples on the tops for the choke. numbers are 327466 on all three carb bodies (I have jets, just need to see
Last Post By: rjdubiel Today, 07:39 AMmake me an offer if anyone can use this.
clean two piece plate adapter plate and tuner. Freshwater, all good to go. May have some solid top mounts, will have to look.
200.00 shipped
Anyone need a good crank? $275 shipped with top cap and bearing.
Thanks
RJ
Hydromotive Quad-IV
Thread Starter: MODVP22Hydromotive Quad-IV 22pitch RH 4 blade. Small shaft. No longer have the project boat so I don’t need the prop. Finish has some blemishes like normal use.
Last Post By: MODVP22 Today, 10:31 AM