Latest PostsComplete engine fresh rebuild w/ 25 hrs Bobs coned gear case 1.87 8,000.00 can ship with buyer arrangements on factory mercury pallet.
Last Post By: KIRCHNER Today, 05:59 PM
Hey all, have the standard looking connector from the stringers to the transom, the end cap that looks like a circle that screws into the bar....anywhere
Last Post By: JKXLREIGHT Today, 05:44 PM
I laugh every time I see this.
Going g to build a tunnel tab to help keep the bow down on hole shot. My tunnel is 34" wide and I found a 36" x 9" Bennett trim tab that
Last Post By: KIRCHNER Today, 04:56 PM
Am I wrong. All the 3.0litre Mercury OPTIMAX, Have more torque & acceleration than any of the newer 4strk's in the same size HP rating. Anyone have
Last Post By: LakeFever Today, 04:23 PM
By Lars Strom
Starting with: Paris 6 hours 1973..OMC V6 victory over Team Mercury.
"My name is Yves Belanger, and this incredible video captures an unforgettable day. Rick Conti and I started early in the morning when
Anyone with hands on experience care to share or at least discuss nitrous tuning for two strokes on here?
There’s lots of discussion and
I need to find someone who can balance a flywheel for me. I am having no luck with this.
Thanks, Carter Powell
Anybody else get this every once and a while?
2025 25' Action Marine Center Console
This is a brand NEW boat not restored. Pass by the shop and see them being built in person.
Selling for a friend
1.87, 20” shaft.
Has been gone through with new seals and water pump.
Spotless inside.
$750 shipped
I bought this prop over the winter from Delaware Rick, I finally got time to try it out on my boat.
It does not work as good as my Mazco Chopper
Tag Cloud



almost fast boat
Thread Starter: berdesThought I'd throw this out again. 21 Skater clone, or 22 Talon ? Something similar?
Last Post By: berdes Today, 06:07 PM