I am debating on whether or not to sell this jack plate & brackets. They came on the XB2003 that I purchased. During my restoration/upgrading of the
Last Post By: Li'l Toy Today, 03:02 AMHi. I have an original OMC 27 SRX prop never used in original box.. Never used. Acceping offers. Thanks .
Last Post By: Schramer Yesterday, 11:28 PMBeen lurking on this forum for a few years now and finally became a member. I grew up on a lake here in southern Wisconsin.Back in the 1980’s I spent
Last Post By: David - WI Yesterday, 11:04 PMThis World is in their past now ... peace be you with ...
Looking to buy a louvered cowl for an inline 6 mercury tower of power. I’m located in central Florida will drive or pay for shipping
Last Post By: wogi Yesterday, 08:15 PMRecently serviced by Tommy Dunn. Replaced anything that needed attention. Will post pics this weekend. $2,100 plus shipping.
Last Post By: DangerNewb Yesterday, 05:19 PMI have 97 225 Carbed OB, 20" leg, Bobs Cone, has Merc Mirage Plus 25" I believe, its on a 21 Challenger (knock off), over a foot of setback,
Last Post By: OnPad Yesterday, 05:03 PMGents all input is welcome and encouraged. This is my first Merc build so I'll need guidance here. I dont have a manual for this motor im running on instinct
Last Post By: LakeFever Yesterday, 03:58 PMLong vs Short Shaft Difference
I have cut down a 20" driveshaft to use in a short shaft engine. I remember years ago cutting 5" out of
I have a like new Tempest plus 26 pitch. Been run very little. Looking to trade it for a 25 pitch tempest plus. It doesn’t have to be perfect I just
Last Post By: Coon Krazy Yesterday, 03:16 PM1992 Summerford STV 19' boat in excellent condition with 1991 Mercury 2.5L, EFI with 280 HP and 2003 dual axle trailer. Race at 100 MPH, ski or cruise
Last Post By: SLOW STV Yesterday, 02:39 PMHitchhiking was common practice
https://www.wbur.org/hereandnow/2020...rica-jack-reid
https://www.youtube.com/watch?v=86qKgK0asGo
SNL went lame for a spell , watched lately and seems there back on track
03' Merc 150 XR-6 carb engine ID#OT649715
CONTROLLER-IGN: Part# 857185T1
Maintenance: I replaced the Trigger (I marked it to
power trim issue
Thread Starter: KIRCHNERre-rigged my ride with a 2.5, single piston trim clamp; hooked my existing lines[same remote pump] which works fine, but motor wont trim. i cracked the
Last Post By: DangerNewb Today, 05:19 AM