User Tag List
Results 1 to 15 of 49
Thread: Taking a second look at omc
Threaded View
-
09-18-2021, 08:38 PM #40
GT 200 fresh water motor out of lake Okachobee area, not sure of year but has white cowels with orange and black graffics, re built with a few grinds. just want to make sure it has all it's original parts re installed. going on a 18' donzi hull ( copy from the guys at scarab as a side project back in the day ) hull only as a center console as a sit down configuration w/foot throttle. heavy hull as it was intended to have BBC and outdrive, something for the snotty water that usually follows me wherever I go. 42 gallon tank in the foreward area to allow some exploreing without worrry of low fuel ( da Keys ). no high end runner but lively enough to at least keep them in sight til the water gets ugly
thanks for your input as it seems like you have been there and done that
Fun Out
most overnite successes usually take at least 10 years

Certified turd polisher,

-
Instigator liked this post
Similar Threads
-
Taking apart a trim ram
By aggiestckl in forum Technical DiscussionReplies: 2Last Post: 04-16-2019, 08:56 AM -
Taking paint off cle.
By SkeeterD in forum Technical DiscussionReplies: 5Last Post: 01-28-2007, 04:28 PM -
Taking it to the next level
By mr.clean in forum General Boating DiscussionReplies: 13Last Post: 08-28-2006, 06:26 PM -
taking a 3 lt omc to 3.6
By charger19 in forum Technical DiscussionReplies: 2Last Post: 11-24-2001, 08:02 PM




Thanks:
Likes: 

Reply With Quote





