Fastest 24 Skater

[vnemous]

Why are all of these uploading upside down?

Turn your computer over

[NICE PAIR]

Attachment 337180

Attachment 337181

fixed it for you. :-)

Attachment 337199

Attachment 337200

[Todd D]

I tried rotating them.... thanks!

This is the boat joe mentioned earlier

[Michael J Giesler]

Holy $hit !!!!!

I have been in your new skater when dave had it 119.8 it was beyond impressive

[vnemous]

We have a customer who Fullers built and rigged 300x's on his 28 skater and it runs 118 on gps

[JerseyChris]

We have a customer who Fullers built and rigged 300x's on his 28 skater and it runs 118 on gps

Is that the 28 that is always tearing **** up?

[mikesufka]

I have been in your new skater when dave had it 119.8 it was beyond impressive

Good to know. I'm excited. Having a bunch of stuff done to it at Valley Motorsports in Eagen, MN, just to clean it up. New gauges, carpet, and moving the rear seat forward two feet. Should be awesome when I'm done. Can't wait to drive it.

MDS

[vnemous]

Is that the 28 that is always tearing **** up?

Yep always looking for a race win or lose

[Flightplan]

I have a set of 50cc chambers being made for the heads on my Simonized motors. It will be interesting too see what the increased compression will do for acceleration and mid range punch. I don't think it will affect top speed though.

Nice motors. So how does Simon squeeze the extra 10hp out of the 300X? What type of mods? ECU, exhaust, intake, compression, other? Just wondering.

[Sea2jet]

I believe its a combination of larger throttle bodies(3.8 inch bore compared to the stock 3.5 inch)and billet fuel rail, ECU upgrade, 7500 rev limit, lightened flywheel, custom heads with removable chambers. Mine came stock with 64cc chambers to be able to run any pump gas. These were originally built for a 21 foot Liberator. I'm now running 100LL, so I have room to bump up the compression. The nice thing is that its easy to switch back at anytime. Eric Simon also installed the Taylor 15" mid sections using all factory parts. They turned out to be too much for the Liberator and found their way onto this 24 Skater.

[RADER]

24 280s between 117 / 120 right condition and dial in.

[WILDMAN]

The 25 Liberator has the same bottom as the 24 Skater. Mine has stock 300XS motors and runs just over 114 on the limiters with 34"x15" Mercury labbed cleavers. It still ran 112 with four guys and 50 gallons of gas.

[baja200merk]

The 25 Liberator has the same bottom as the 24 Skater. Mine has stock 300XS motors and runs just over 114 with 34"x15" Mercury labbed cleavers. It still ran 112 with four guys and 50 gallons of gas.

What's that liberator weigh?

[WILDMAN]

The bare hull with tanks weighed 2080 lbs

[eli]

I have a set of 50cc chambers being made for the heads on my Simonized motors. It will be interesting too see what the increased compression will do for acceleration and mid range punch. I don't think it will affect top speed though.

you running low water pickups ?