White Is Wonderful!(post Omc Pics Here)

**Laker** · 02-03-2009, 06:50 PM

Originally Posted by RTD327

mostly I just would like a good idle in gear.
Rick

Its NOT the ignition coils causing bad Idle.

**BeefKid** · 02-03-2009, 07:33 PM

my action with the stock 200 gt... put the fitch hood on it

**baja200merk** · 02-03-2009, 07:36 PM

wtf is idle?

**RTD327** · 02-03-2009, 08:24 PM

It needs to idle out of the sand bar at least. Without dying three times. So you guys are thinking its fat on idle?

Rick

**Streamin101** · 02-03-2009, 08:34 PM

Dont be afraid to post some gps #s on the action wit tha loopa.

**RTD327** · 02-03-2009, 08:37 PM

64mph gps is all lots of ski time on this motor also has a 23 four blade

**BeefKid** · 02-03-2009, 08:38 PM

Originally Posted by Streamin101

Dont be afraid to post some gps #s on the action wit tha loopa.

haha... nothin big yet man. still a stock looper

... seen 83 with a 30p chopper on the limiter

.... got a 32 cleaver want to try, supposed to be good for that boat top end wise and the limiter shouldn't be ther much longer... we'll see

**RTD327** · 02-03-2009, 09:01 PM

Im going to raise the motor an inch this spring.I think its to deep no rooster tail ?

**Action Dave** · 02-04-2009, 09:42 AM

Originally Posted by RTD327

It needs to idle out of the sand bar at least. Without dying three times. So you guys are thinking its fat on idle?

Rick

What kinda rpm are you seeing in gear, at idle? Might be as simple as synch and link. It should be idling around 650-700RPM in gear.

**Riverman** · 02-04-2009, 09:45 AM

Mine wouldn't idle either when warm. Turns out one of the reeds was held open by a burr on the reed block. Bad reeds can surely cause idle difficulties.

**Action Dave** · 02-04-2009, 09:56 AM

Originally Posted by Riverman

Mine wouldn't idle either when warm. Turns out one of the reeds was held open by a burr on the reed block. Bad reeds can surely cause idle difficulties.

I was just gonna suggest the same thing. Did any of your carbs spit back fuel?

**Riverman** · 02-04-2009, 10:00 AM

Yeah a bit, but I was told that was normal. It was probably a combination of things. The idle got a little better when I added exhaust reliefs. I brought the mid to work today to open up the relief slots a little more, to slightly larger than stock, which is two 1/2" holes.