Can someone inform me if the 250XB and the 300X use the exact same pink tip fuel injector ?
Thanks
Larry
Combustion Engines versus the ...political environment.
Three times a charm so they say. As of today the hull sits bare, cap separated, all core and transom removed. Layup is going to be balsa core set in ATC
Last Post By: Hippie459MN Today, 10:11 AM.
Rey Marino (may he rest in peace) would be very proud right about now to see his work become a world record holder
Been lurking on this forum for a few years now and finally became a member. I grew up on a lake here in southern Wisconsin.Back in the 1980’s I spent
Last Post By: LakeFever Today, 09:29 AMATTACH]
Fresh Dave Bush Build with around 30 hours.its punched to 3.4 liter and runs very strong
39K
I laugh every time I see this.
re-rigged my ride with a 2.5, single piston trim clamp; hooked my existing lines[same remote pump] which works fine, but motor wont trim. i cracked the
Last Post By: Jim Speros Today, 07:57 AMI am debating on whether or not to sell this jack plate & brackets. They came on the XB2003 that I purchased. During my restoration/upgrading of the
Last Post By: Li'l Toy Today, 03:02 AMHi. I have an original OMC 27 SRX prop never used in original box.. Never used. Acceping offers. Thanks .
Last Post By: Schramer Yesterday, 11:28 PMThis World is in their past now ... peace be you with ...
Looking to buy a louvered cowl for an inline 6 mercury tower of power. I’m located in central Florida will drive or pay for shipping
Last Post By: wogi Yesterday, 08:15 PMRecently serviced by Tommy Dunn. Replaced anything that needed attention. Will post pics this weekend. $2,100 plus shipping.
Last Post By: DangerNewb Yesterday, 05:19 PMI have 97 225 Carbed OB, 20" leg, Bobs Cone, has Merc Mirage Plus 25" I believe, its on a 21 Challenger (knock off), over a foot of setback,
Last Post By: OnPad Yesterday, 05:03 PM
Official 22 velocity speed and set up thread.
Thread Starter: aaronmt73Ok I read through all the other 22 Velocity threads.How bout everyone post there speeds.
Last Post By: Sipes12 Today, 12:53 PMMine is as follows,
Year:1998