Looking for 12x22-23 13 spline cleavers
Last Post By: Roflhat Yesterday, 11:45 PMHey -
Im looking for the 5” midsection/driveshaft extension for a 3.0 liter Merc
Hoping someone has one stashed
Thanks!
Gidday guys.
Years ago there was a magazine article (Bass & Walleye?), where they did a heap of aftermarket upgrades to an Evinrude
.
Rey Marino (may he rest in peace) would be very proud right about now to see his work become a world record holder
Believe it or not, this was not touched by Photoshop, except to just make it smaller to post here. The image was shot on the Great South Bay, Long Island.
Last Post By: oldschoolltv Yesterday, 08:18 PM.
Pantera building a plug from an original 24 footer
Is the gasket between carb and intake supposed to cover this hole in pic #1? In Pic #2 the the mixture screw is at the other end and in the middle there
Last Post By: Ron C. Yesterday, 06:18 PMTry to figure out why my 200hp merc is overheating, This is the second powerhead and both seem to do the same thing, I got a better run today with the
Last Post By: Aaronhl Yesterday, 05:45 PMI have a 2nd hand Brucato 3.0L promax slide front forsale $1000.00 ono
Thanks
Rick
2011 stv euroski (full throttle)
pristine condition
orginal 2.5l efi 280 ros never been rebuilt very low original hours
ecu tunned
Evinrude outboard Motor 175 HP Runs great.
V6 2 stroke 25 inch shaft. Shifts good.
Power trim and tilt works good.
Runs on Premix. VRO
I,m looking for parts Yamato Model 80
Can anyone help ?
Hey guys I’m looking for some oversized pistons to rebuild a pair of Suzuki DF 150 4t engines and came up empty on eBay. Was wondering if anyone knows
Last Post By: pcrussell50 Yesterday, 02:38 PM
Off centered motor on a single V Hull
Thread Starter: LeonardGHi,
Last Post By: LeonardG Today, 12:17 AMBought an Exocet 23 (piranha hull with phantom deck) and I put a 300 R, 1.75 TM, on it (not an SM, no hydraulic jackplate on it).