Mercury v6 offshore 15 inch mid with saddle and long race trim ram with pipes. $4250 + shipping
Last Post By: driver510 Today, 04:13 PMWTB: Mercury 3 Blade RH, 14x28 or 14.5x28 Cleaver, 15 spline / thinner early blades preferred.
If you have one for sale, please shoot me
2010 Evinrude E-Tech, H.O., 200HP Outboard. Runs well. Compression is 1-125, 2-125, 3-130, 4-125, 5-130, 6-125.
Controls are available as well.
Hi,
Bought an Exocet 23 (piranha hull with phantom deck) and I put a 300 R, 1.75 TM, on it (not an SM, no hydraulic jackplate on it).
Have a 1993 XR6, 4-1/4" lower unit, clean freshwater unit, 20" RH, 1:78 gears, new seals. Part #1674-814247-C.
$600 or best offer, prefer
Can a rough idle be possible due to an injector or two being out of spec and not flowing properly?
thanks, Carter Powell
I have a 1997 Bullet XRD. Was garage kept its whole life before I purchased hull a couple months back. Installed my 2.4 carb 200 on and loved the boat
Last Post By: GiantCrouton Today, 11:08 AMFor Sale 32 pitch Bravo FS. It is as it comes out of the box. No work or repair has been done to it. It has very little run time. So it is in excellent
Last Post By: aj06bolt12r Today, 10:58 AMThree times a charm so they say. As of today the hull sits bare, cap separated, all core and transom removed. Layup is going to be balsa core set in ATC
Last Post By: LakeFever Today, 10:55 AMBobs PN 201-102xxx
Bigfoot model: dual hose bigfoot
Bought back in 2014, got put into long term storage
Original box etc...epoxy
stock 280 see pictures in hulls under 20' everything you need !
Last Post By: drakeyoungx Today, 09:32 AMI laugh every time I see this.
https://youtu.be/4Olk5AU_tfg?t=296
Last Post By: doug7488 Today, 06:16 AMhttps://www.nbcmiami.com/news/local/...e-bay/3308912/
Last Post By: noli Today, 04:42 AM
Girls and Boats
Thread Starter: Old fiberglassSeen a lot of old boat racers talk about boat racing......Lilabner got me thinking in one of his other posts. What about pictures the females back in
Last Post By: Lake X Kid Today, 04:44 PM