Who - Cut and weld yamaha 15 mid

[kellytheaker]

Anyone have a contact for cutting and welding a 90 yamaha mid / 20 inch to 15 .
Thanks
I did ask Cuda for Marty Powell a number but he is not responding .

[108]

It will be a couple months due to busy but I'm building a jig table to do mids.

[CUDA]

WHAT !

Marty Powell 727 742 1235

I dropped off my mid on Thursday

461 Lakeside Place
Largo Fl
33771

Just got back from Monty Racing

Gordon has been in the same shop for 30 years, I believe.

He's one of the GOOD old Boys

BY the way, Marty has a can just like mine, 90 Yamaha already made,

Said he did it many years ago, said the guy changed his mind, so you might save yourself a big buck if you could use it, I bet he'll sell it cheap, not doing him any good.

Since your from Canada, the section he showed me is light,




PS I don't see a PM from you ? about marty?

[kellytheaker]

Sent Marty a text and a couple calls - no response

[CUDA]

I know he has a cabin in NC ?

Patience

[kellytheaker]

Thanks helps to know - appreciate the effort

[kellytheaker]

Sir I have had a conversation today - the mid you dropped off is a Yamaha 90 correct - just ensuring we are dealing with same application . I think mine is 90 odd model year - not sure if all the same but both mids he has are same .

[CUDA]

Yes, 90HP 2004, Monty's boring 20 over and finger porting, going to 175 compression.

The new boat is said to be 200 lb. bare hull. should move

[kellytheaker]

Appreciate the reply .

[CUDA]

Appreciate the reply .

What boat are you putting yours on?

Do they have any small boat racing in your area? if so, what classes?

[kellytheaker]

New generation Voodoo from Spaeth

[kellytheaker]

T850 and 750 but I am not involved . This will be a lake boat that is capable . Thanks for the help with the mid . I have been waiting to find a mid and I am not that educated on the rest of the process - - suspect shorten the water tube and shaft - Who is doing the shaft for you .

[Greg G]

Ok we need several proper pictures of your Voodoo. That looks very interesting. Please post

[kellytheaker]

I have not taken allot of pictures - the hull is currently being fitted for a cover . The hull is still the same Hydrostream voodoo 14 ft but a new cap was produced by Spaeth who produced several Hydrostreams over the years for Canada . Rear hatch is new as well as drop floor - lowering the seat area a few inches .
Right now getting a mid is the reason for the post and a driveshaft shortened is the need since the new hull Transom is 15 inches vs the old at 20 inches .
I will post up some pics when it’s back in the garage with a cover . Thanks for the interest .

[kellytheaker]

Visually here is the differant cap vs the old -