1600 rpm max follow up

[coffeeguy]

As stated previously tested first with the merc efi tester. Cyl 1&2 injectors( pinktips) clicked but not very loud like 3&4 or 5&6. Pulled of the laser front annd ohm tested the injectors . Cyl2 had less then half the resistance of the rest(1.2 ohms vs 2.5). Tested flow on cheap amazon injector tester and found #2 didn't flow at all. It dripped when it was suppose to be sealed ., nothing when getting pulses. All the rest were with in a couple of cc's on the timed tests. Threw them and a replacement(used ) into the electrostatic cleaner and tested . Now all of them were working. Will reassemble tomorrow and hope for the best. I did read if one injector is acting up ,it can effect the other one its "paired with". I don't know if this is true but I hope so. Not in ecus drivers as a new Brucatto and known good used Merc were swapped in and out.

[coffeeguy]

Cleaned injectors and mild flow test . Threw out the bad one and replaced it . Took boat down to ramp and bingo reved up(on trailer in gear) . So threw it in the water and everything was good. Maybe the 1600 limit tells that it may be an injector problem as there were a few write ups that hit the 1600rpm wall. 1 more thing to check and eliminate anyway. That all that shot answers to my many questions.

[hydra-sports]