OLD Mercury V6 Engine Mounting Bolts with hydraulic trim passage fitings.

[W2F a V-King]

Looking for a good set of these bolts. Trying to find the part number to list, but as of yet no luck.

I remember these being a pain to get in and out sometimes, but am needing a set in good condition for a project.

The Mercury shop manual just calls them "Hydraulic Connectors", but double as the lower engine to transom mounting bolts.

Thank you,

James H.
4234291249textorcall
acts2-38 at charter dot net

[rock]

What is the difference tween port and starboard bolts? I have a couple you can have but they look about the same to me other than one has an extra inch of thread.

Rock

[W2F a V-King]

PM sent to you Rock.

Thank You.

[W2F a V-King]

I vaguely remember that... ahh the 70's were too much fun ... but I did have a 77 1750 and a 79 200 in those same years, and remember the hassle of them with removing and replacing them...

Trying to fab up a hydraulic jack plate that sets as close to the transom as possible ( don't want any, or as little as possible set back if possible ), and don't like running hoses over the transom. I Like the old Land & Sea ones from years ago. Been in contact with Bob, getting ideas.

Would appreciate any thoughts on doing this?

Appreciate the information, I did not recall that until you mentioned it.

Thank You,

James H.

[rock]

Nice save Pete. Been so long since I used them I completely forgot and had already boxed up two for the same side. Corrected that and they will go out no later than tomorrow morning James.

Rock

[W2F a V-King]

Thank You Rock !!

You will send me payment info to please.

[W2F a V-King]

Received those bolts today!

Thank you Randy, they will work perfectly

I hope to be able to return the favor some time

James H.