User Tag List
Results 1 to 4 of 4
Thread: Ignition system
-
08-07-2016, 11:07 AM #1
5000 RPM
- Join Date
- Oct 2004
- Location
- lehighton, pa
- Posts
- 117
- Thanks (Given)
- 18
- Thanks (Received)
- 0
- Likes (Given)
- 37
- Likes (Received)
- 8
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Ignition system
Can you use the same wire harness and key switch from a 2.4 to a 2.5 both are carb motors. Boat starts but runs like crap. Seems like it's missing then does like a hard shut off. I looked on the cat I never had a fuel regulator on that boat and it ran. I did have 1 coil wire bad, fixed that. To be honest I thought it ran better with that coil wire bad..Any ideas?
-
08-07-2016, 11:55 AM #2
Harness should work fine.
Dave1980 Cougar 19 tunnel,90 2.4L Bridgeport EFI in middle of restoration.
1988 BAJA Sunsport 186, 96 225 Pro Max
79 12' Auminum, 95 Merc 9.9
RIP Stu
"So many idiots, so few bullets"
-
sicknick12 thanked for this post
-
08-07-2016, 03:36 PM #3
Back in the day I had an old '78 175 Black Max that wore me out for a week.....finally found that the big ground cable had work-hardened and broke almost in to where it goes through the cowling!
-
sicknick12 thanked for this post
sicknick12 liked this post
-
08-08-2016, 02:59 PM #4
5000 RPM
- Join Date
- Oct 2004
- Location
- lehighton, pa
- Posts
- 117
- Thanks (Given)
- 18
- Thanks (Received)
- 0
- Likes (Given)
- 37
- Likes (Received)
- 8
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Thanks guys, Yes I had a few bad wires I narrowed down going from the packs to the coil
Similar Threads
-
Complete CDM ignition system
By 2.5-21 in forum Misc. Parts and AccessoriesReplies: 2Last Post: 09-30-2015, 02:12 PM -
MSD Ignition system
By Doran59 in forum Technical DiscussionReplies: 1Last Post: 08-25-2008, 06:39 PM -
OMC Ignition System
By imq707s in forum Electronics, Audio Systems, and WiringReplies: 0Last Post: 07-02-2004, 03:43 PM




Thanks:
Likes:
Reply With Quote





