T2x/tillotsen carb rebuild kits

[mrcrsr]

I know Chrysler/force used tillotsen carbs. Does anyone know an application that I can order carb kits for?

[FUJIMO]

...This should be the "repair' kit. Has more pieces to it, than a rebuild kit. Hard to find.

[FUJIMO]

www.carburetor-parts.com Mike has a number K-5004 "rebuild" kit. Don't know if it will help you or not. What numbers are on your carbs? Parts & pieces(carbs) get changed over time.

[baldad45]

I think any 120+ hp 4 cly, Chrysler/force will work , If you look through Droll's posts I think he listed specific kits .

[mrcrsr]

Thanks guys, I'll try and get the carb numbers tonight. It's been a pita trying to get the correct pistons for it. Looks like special order wiseco is going to be the only route.

[home made tunnel]

TSM performance has rebuild parts for Chrysler / force.
What are you looking for? I use MarineEngine.com and Crowley marine... take the part numbers, and often cross-reference them on Amazon.com. Usually, the websites themselves are cheaper than amazon! Often, individual carb pieces needed are cheaper.
What's the engine you're working on?

[FMP]

TC1A or ?

[Tom Smyth]

if you contact tillotson they still sell carb kits for the TC carbs.

[FMP]

The later TC as found on F5 etc are a bit different than the earlier ones.

[mrcrsr]

Here's what i have tc3 a3

[mrcrsr]

TSM performance has rebuild parts for Chrysler / force.
What are you looking for? I use MarineEngine.com and Crowley marine... take the part numbers, and often cross-reference them on Amazon.com. Usually, the websites themselves are cheaper than amazon! Often, individual carb pieces needed are cheaper.
What's the engine you're working on?

They are off a Mercury t2x

[mrcrsr]

Here's another question also, the other engine I have has carbs that are slightly different, the first set from the above number has 2 tubes going up inside the Venturi, the second set off the other engine have 1 tube in the Venturi. Which is a better set to use. A friend said that the carb with the 2 tubes is better. Here is the part number off the other carbs.

[FMP]

The other TC?, Any of the earlier 123456A are virtually the same.

[mrcrsr]

The other TC?, Any of the earlier 123456A are virtually the same.

I bought 2 powerheads, one was missing crank rods and pistons but is otherwise complete, so I was trying to figure out which set to use for the build. So basically the carbs are the same as far as the carb kits

[FMP]

I think the earlier TC1A may have had the single pick up tube. I'd have to ask the 135/15O Stacker Bill Edwards to be sure. Maybe they had two version. The TCs I have all two tubes I believe, going to check.