Believe it or not, this was not touched by Photoshop, except to just make it smaller to post here. The image was shot on the Great South Bay, Long Island.
Last Post By: doug7488 Today, 08:45 AMAnyone have a 300xs air compressor they want to part with? A source where to find one would be helpful too. Thanks in advance.
Last Post By: sonicss33 Today, 07:51 AMMy 175 XRi decided to lose some compression on 2 cylinders. Probably my own fault. Had an external water pickup and i think it overheated a little bit
Last Post By: blackmaxonly Today, 07:47 AMLet's see...
Last Post By: Merc Speed Today, 06:26 AM1987 24ft skater with twin 300promax’s. boat was completely redone a few years ago with new paint and interior. Engine hours are unknown but boat runs
Last Post By: harris_teddy Today, 06:26 AMLooking for a replacement face plate for mercury 4 clyinder chrome surround. Thanks Rick
Last Post By: delawarerick Today, 06:19 AMNice Chopper prop. 22P 14.5 D
Line cutters have been modified to fit both a 4 1/4" and 4 3/4" case.
Few small nicks and scratches.
2.4/200
-starts and idles like a champ
-screams up to high rpm under no load
-screams when it is on the mains
BUT
32 Max 5 ST
Clean edges and blades. No issues with prop. I sold my old boat as I bought this and don’t use it on my current boat.
Finished taking my 2.5 260 horn motor apart today after a rod went thru the block on #6. The bottom crank seal was sucking water and air and that's
Last Post By: wogi Yesterday, 08:42 PM98 200 efi with a 260 cover. Everything related to the power head and two piece adapter plates are factory 98 pieces. All cooling is routed as per factory
Last Post By: LakeFever Yesterday, 08:07 PMWanted a Quiksilver control box top mount, with trim and tilt single motor
i am in new jersey
I just had a rod go thru the block on my 2.5 260 and all the plugs were white! Last week they were normal tan. What are some of the things that would
Last Post By: LakeFever Yesterday, 06:51 PMI expect quite a few here have seen this photo of a one off CVX 20 Surface drive from back in the 70's.
I know nothing about
Post your Favorite Memes Here
Thread Starter: KrazymaanI laugh every time I see this.
Last Post By: doug7488 Today, 08:47 AM