Smartcraft

[tj309]

The water pressure gauge won't work. I've tried 2 different gauges. The gauge before and after theWP gauge in the daisy chain work just fine. Any ideas?

[aj06bolt12r]

Has it ever worked? Did you OHM out the sender?

[David - WI]

Don't you have to "configure" those CANBUS gauges so they all match the "starboard" (or "port") setting on the motor?

[tj309]

Has it ever worked? Did you OHM out the sender?

Neither gauge ever worked. All the rest work just fine. I did not check the sender, any idea where it is on a 150 4 stroke?

[25two.stroke]

Neither gauge ever worked. All the rest work just fine. I did not check the sender, any idea where it is on a 150 4 stroke?

Probably does not have a water pressure sender installed. 150 4s don't come with them, you have to buy separately and install yourself. There is a pigtail in the main engine harness for it, but its just capped off.

[tj309]

Thanks! Where is the pigtail located?

[25two.stroke]

Exhaust manifold area. Right where the sensor goes

[tj309]

Right under the alternator?

[25two.stroke]

Right under the alternator?

Yes

[tj309]

Thanks, I found the pigtail and the plug where the sensor goes.