Offshore Clamp Trim Actuator

**dnr78** · 02-15-2013, 11:21 AM

[QUOTE=Donat;2438498]Dan why not ask around? I have one that u could take measurements of . I'll be at bottoms up tomorrow. Call or text 7737320992.

Mike did Chaz made it from screech? Looks great btw[/QUOTE

I call it pent up winter time boredom

**vnemous** · 02-15-2013, 11:29 AM

Originally Posted by Donat

Dan why not ask around? I have one that u could take measurements of . I'll be at bottoms up tomorrow. Call or text 7737320992.

Mike did Chaz made it from screech? Looks great btw

He actually had them layed out for himself all ready just bends them for port or starboard.

**Chaz** · 02-17-2013, 10:43 AM

Originally Posted by Donat

Mike did Chaz made it from screech? Looks great btw

Yea it's scratched a little ... I dont do window's either ..

All kiddin aside , it's never easier to cut out a dozen of em while the plate is on the table and the plasma is in your hand ..

Me and my big mouth .. 43 degree's at daybreak this mornin ..

**Tom Foley** · 02-17-2013, 02:14 PM

Nice job Chaz!

**Chaz** · 02-19-2013, 08:30 AM

Originally Posted by Tom Foley

Nice job Chaz!

We both know it was "reverse engineered" ....

**dbug10** · 07-03-2013, 12:52 PM

Chaz can you make one for a 15" 2.5 offshore I bought a new motor which is the 2.5 to replace my old 15" 2.4 and the factory 15" 2.5 takes a different actuator than the 20" cut down to 15" 2.4 mid uses and $350 from SM is redicolus