Project - Ultimate Gambler

[NeedOne]

Appreciate you raising the point, it is approaching the point of hull needing to sit in a jig.. The hull is actually really solid so far. Not flimsy at all.

The project has blown past every contingency it could.. whole foam being wet and now I am concerned stringers are going to need to be done..
The stringers are solid, pass a hammer test, and i cannot see any rot, but I think with how saturated the foam is, it must have gotten to the stringers. One thing I cannot tell is if it has a core.. it seems like solid glass, need to get the foam out and fully assess.

Adjusted plan is now:
Grind & Cut out remaining liner
Remove all foam
Assess stringers & core. if need replaced:
Build jig, set hull on jig

Any reference thread with pics you'd recommend for jig design? Thank you