Allison XB2003 w/2024 Yamaha 175 SHO

[Hydrodreams]

I have an opportunity for a change. This beautiful 1994 Allison XB2003 Hull#33 Platinum and Black in great condition is up for grabs. Hull only has approximately 200hrs on it. 2024 Yamaha Stock 175 SHO w/35 hrs and 4 YEARS warranty remains. Boat has been completely redone from the bow to the stern. It handles absolutely great with the 175 SHO. With either the stock or coned lower unit. She ran 85 mph on a rail with the stock ECU. I am sure she is a low to mid 90's boat if flashed. She sips gas at 10mpg while cruising. This is basically a next to new boat with all the modern features. List of upgrades below. PM me with any questions you won't be disappointed, no expense spared.
$38,000

2024 Yamaha 175 SHO w/ 35hrs and warranty until 9/2029 (Stock-Not Flashed)
New HydroTec Solid Motor Mounts
Two 1.86 Ratio Lower units One Stock One Coned (No exterior hose)
Two Props
26P 4 blade Hill
Spinelli 29P 3 blade
Custom Gray Decals
New HydroDynamics 12" Jack Plate
New Allison Fuel Tank
New Fuel Lines and 10 Micron external filter
New Lockable Fuel Fill Cap Assembly
New Auto Bilge Pump
New Wiring
New Custom Switch Panel
New NoCo Three Bank Battery Charger
New Ignition Switch
New CL7 Yamaha Display
New Garmin 93SV Graph
New Hyd. Steering
New Allison Steering Wheel
New Yamaha Throttle Cables
New SeaStar Pro-Pedal Foot Throttle
New Turn Signal Style Trim Switch
New Carbon Fiber Dash Panels (Have stock panels)
New Seats Buckets and Bench
New Allison Short Windshield (Have Original Tall Windshield)
New Allison Decals
New Custom SeaDek
New Hardin Shifter
New Shift Cables
New Latches
New Deck Lid Seals
New Boarding Ladder/Step
All New Hardware
New Custom DryLock Cover

2006 Boatmate Trailer in great condition
New Wheels and Tires
Vault Style Hubs
New S.S. Ratchet Tie Down Straps
LED Lights

[John S]

Gorgeous rig. Did you try any other setbacks for the motor? I would've thought with a 4 stroke, it would like less setback. But in your pics, it seems to run right.

GLWS

[Hydrodreams]

Gorgeous rig. Did you try any other setbacks for the motor? I would've thought with a 4 stroke, it would like less setback. But in your pics, it seems to run right.

GLWS

Thanks John, no went with the 12" after contemplating between the 10" or 12". She handles great and comes out of the hole fantastic. Very little bow rise on take off and no porpoising. Absolutely love the way it rides.