User Tag List
Thanks: 0
Results 1 to 5 of 5
-
01-21-2024, 08:34 PM #1
Stainless marine trim setup for a 15" Merc mid
I need the bracket, with the cable actuator, and the pin with the extension rod that mounts in the swivel and runs out to the bracket. Basically everything that mounts to the mid & clamp bracket. I do not need the cable or the trim gauge, just everything that mounts on the mid/swivel.
Thanks, SchramerI have a boat or two.... that I never get to drive
-
01-22-2024, 07:14 AM #26000 RPM
- Join Date
- Aug 2015
- Location
- Southeast
- Posts
- 1,070
- Thanks (Given)
- 134
- Thanks (Received)
- 80
- Likes (Given)
- 48
- Likes (Received)
- 615
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Bullet CC w/ 225 Promax - Sold
STV ProComp w/ 225 Promax
STV Procomp with 280
25 Liberator "The Battleship"
Blazer 650 Pro Tour
-
01-23-2024, 06:24 PM #3
I just ordered two straight from stainless. I tried to find one used for 2 years and could never find a complete setup. I may be interested in the dash mount piece you have if you end up buying a complete setup. I would fab the rest of the parts needed to make it work.
-
01-23-2024, 08:21 PM #4
Your enthusiasm on this subject is inspiring guys haha!! I figured it was a long shot and wanna punch myself in the dik cause I had the bracket & pin on my mid that has been in storage for a bit. I took the parts up North by my buddy's place to use on his mid since I had no reason to get it ready for water in the near future.....of course, we end up using the pin pieces but Paully already had the bracket for the clamp so we didn't use that part.
6 months later, I found a good reason to get my 15" mid ready to use this summer & POOF, the frickin bracket is gone like a fart in the wind....FML. My fault for loosing it but life goes on. This setup may be temporary so I didn't want to buy new just to store it away again lol. I only got lucky in the "wanted" section once before, shout out to Mr. 25twostroke above for that, but it was still worth a shotI have a boat or two.... that I never get to drive
-
01-23-2024, 08:29 PM #56000 RPM
- Join Date
- Aug 2015
- Location
- Southeast
- Posts
- 1,070
- Thanks (Given)
- 134
- Thanks (Received)
- 80
- Likes (Given)
- 48
- Likes (Received)
- 615
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Stainless will sell individual components rather than the entire set up. Lettie (not sure on spelling) has sold me small parts I've lost over time.
Bullet CC w/ 225 Promax - Sold
STV ProComp w/ 225 Promax
STV Procomp with 280
25 Liberator "The Battleship"
Blazer 650 Pro Tour
-
25two.stroke liked this post
Similar Threads
-
Stainless marine trim indicator setup
By kellytheaker in forum Parts WantedReplies: 1Last Post: 08-17-2019, 04:53 PM -
4" Stainless Marine Jack Plate setup
By ghost28 in forum Misc. Parts and AccessoriesReplies: 0Last Post: 02-25-2014, 12:53 PM