Calling all Laser 380 Ray Gurus

[boybadone]

Thanks, we have a set of Simrad IS35 digital gauges and I believe water pressure has been hooked up. Just need to find it on the interface. What pressure do you recommend? I am reading 12-18 psi at WOT is acceptable.

[OnPad]

Not familiar with your etec, but that sounds about right.
You basically don't want much less pressure than you have at the moment. You can raise the motor in small increments till pressure drops off, then drop it down a hair.
At speed is where you will end up water starved if your too high.

[trbocharge]

Keep jacking the motor. Too much prop in water will give you that chine walking issue.

[boybadone]

Thanks, trbocharge. We have lifted the motor and it seemed to help. There is a bit of damage on the prop, so we are going to send it out and see if that helps as well.