225 ProMax 15" mid, CLE 3 hole

[Jkissel20]

SOLD pending funds

Merc ProMax 225 rebuilt winter of 2020 with 60 hrs currently. I added 10 hours during past two seasons and sold the STV hull this was on.

$9,000

Replaced green merc graphics with stock colors. Included picture of old decals because it is a good picture of the midsection.

- The engine has been completely rebuilt. Machine work performed by James Perry.
- Block was bored .015 over and decked.
- Oiler gear has been gone but James filled the void in the block.
- WSM 1.5 MM ring Pistons, ring gaps measured .019 - .021, all new bearings, steel caged rod bearings, gaskets.
- CCM reeds on lapped cages. An extra set of TDR reeds will be included.
- Heads were machined and measured to 36cc by JSRE.
- VST has been deleted, replaced by a Bosch 044 remote fuel pump, an Aeromotive regulator, and two Aeromotive in-line filters. The pre pump filter is 100 micron and the after is 10 micron.
- All AN fittings and ethanol resistant hose.
- David Dreifort butterfly throttle linkage upgrade.
- New trigger, stator, regulators, and switch boxes.
- Lighter weight flex flywheel. You will also get the heavy flywheel as well.
- A new Brucato ECU with 225 ProMax fuel curve and a 7200 limiter.
- New NGK plug wires
- OEM lightweight Alien Cowl and pan are in excellent shape. Skirt has a small crack that was repaired you can hardly see from a few feet away.

Drag4 30” not included but available at a discount with motor purchase.

[Short Shaft Racer]

PM Sent.