User Tag List

Page 2 of 2 FirstFirst 1 2
Results 16 to 16 of 16
  1. #16
    Join Date
    Jan 2002
    Location
    TX......somewhere?
    Posts
    6,448
    Thanks (Given)
    4
    Thanks (Received)
    360
    Likes (Given)
    154
    Likes (Received)
    1046
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    yes sir.. they will fit in tha square "looking" slot (right in front/low of tha flywheel) on both cowl housings.. tha bracket has two hole that go on tha tha bracket that aligns tha two cowls.. it has three holes for tha sols. they will will share tha center hole......

    you can also fab a bracket with 1x1 angle to fit on tha starb. side of tha reed plate, jus foward of tha starter mounted vertical under a coupla "longer" reed plate bolts... but ya gotta relocate tha enrichner either higher or lower...... but that was with tha plastic tubes removed from air box........ or stacks.
    Last edited by tlwjkw; 04-01-2023 at 03:39 PM.

  2. Thanks pcrussell50 thanked for this post
    Likes pcrussell50 liked this post
Page 2 of 2 FirstFirst 1 2

Similar Threads

  1. 2000 Optimax Starter Solenoid mounting?
    By offthefront in forum Technical Discussion
    Replies: 1
    Last Post: 09-11-2020, 07:52 PM
  2. trim solenoid
    By tcrabtree in forum Technical Discussion
    Replies: 1
    Last Post: 10-07-2009, 04:27 PM
  3. Trim Solenoid
    By bill mason in forum General Boating Discussion
    Replies: 5
    Last Post: 10-10-2001, 08:42 PM
  4. trim solenoid
    By bill mason in forum Technical Discussion
    Replies: 0
    Last Post: 10-10-2001, 02:47 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Chris Carson's Marine