User Tag List
Thanks: 0
Likes: 0
Results 1 to 1 of 1
Thread: 1991 22-Daytona/300XS
-
10-10-2022, 07:31 PM #1
1991 22-Daytona/300XS
Can someone on here tell me where they ended up with motor height on this combination.My 21 Daytona ended up being best all around 1/4 below the bottom with the motor on the factory engine plate.It planed good and handled the best there. would rather not have to deal with using a jack plate.There is a step in the transom forward then dropping down to the center pod so the motor is another six inches away from the bullet on the sporty,this is currently where it is and it's too deep
Similar Threads
-
1991 Eliminator 22 Daytona 2.5 260's
By Outdrive1 in forum Hulls larger than 20'Replies: 8Last Post: 02-14-2018, 01:02 AM -
1991 19' Eliminator Daytona full tunnel hull and trailer for sale
By capteliminator in forum Hulls up to 20'Replies: 15Last Post: 06-28-2015, 09:51 PM -
2008 Eliminator Daytona 27, twin 300XS
By extremeskater in forum Hulls larger than 20'Replies: 4Last Post: 10-15-2014, 02:05 PM -
Prop? 300XS - 21 Daytona Eliminator.
By FLTPLAN in forum Props, Setup, and RiggingReplies: 18Last Post: 05-27-2010, 03:28 PM