User Tag List
Likes: 0
Results 1 to 4 of 4
Thread: what and where
-
06-30-2022, 09:54 AM #1
what and where
2005 75 horse 4 stroke Yamaha probably first service. Steel collar 1" long outside diameter1.1/8" inside diameter just over 3/4". Came out when pulling lower unit. Was on driveshaft and looks to be brass. Looked up into mid and it looks as if it may sit above circlip but i am not sure. So question is what does it do and exactly where does it go and more importantly is it critical, Thanks.
RockTeam Junk
No sparkling wiggles in here, only dump truck grinches.
"Screamin Heathen"
-
06-30-2022, 10:21 AM #2
Is it #23 & #24... "driveshaft bushing" in the bottom of the mid?
https://www.megazip.net/zapchasti-dl...asing-10733671
Let's just go ahead and make America great again!
-
rock thanked for this post
-
06-30-2022, 01:06 PM #3
I assumed it was a stabilizing bushing as there is an area on the driveshaft that was shiny but I wasn't sure. It was fused to the driveshaft and removal of the lower was nearly impossible. I think the corrosion that is everywhere on this thing was what was holding it in place. You can see the circlip is distorted after forcing the bushing past it. Appreciate the reply David.
RockTeam Junk
No sparkling wiggles in here, only dump truck grinches.
"Screamin Heathen"
-
06-30-2022, 01:14 PM #4
Quiet a bit online about those bushings "squealing" like an old alternator belt... bushing is supposed to be cleaned out and greased occasionally with some "special" yama-grease.
Let's just go ahead and make America great again!