Merc oil vacuum line routing?

[Keaten]

I've recently got a Merc 2.4 carb motor and the previous owner decided he was going to mix match some random ass hose combinations. So, I ripped it all off. Start over fresh. Can someone send me a picture of each side or a diagram of each side so I can continue re-pluming my new tygon yellow 1/8" fuel hose. Thanks.

[Keaten]

6 hose lines by the way thanks

[rgsauger]

I’ve got a 2.4, too. Can send pics of the manual tomorrow

[ChrisCarsonMarine]

On each side,intake to cylinders
top to bottom,bottom to middle,middle to top,Chris

[tlwjkw]

try these.....

[ChrisCarsonMarine]

try these.....

If it was a 2.5,He asked about a 2.4,Chris

[tlwjkw]

which ones are different?

[ChrisCarsonMarine]

which ones are different?

As your diagram...
Going from cylinder to front,P port,S starboard
P2-S5
P4-P1
P6-P4
S1-S3
S3-P6
S6-S2

[tlwjkw]

gottcha, but it still works jus fine on either 2.4 or 2.5.. least it did for my junk........... those drawings jus say V6?

[ChrisCarsonMarine]

gottcha, but it still works jus fine on either 2.4 or 2.5.. least it did for my junk........... those drawings jus say V6?

On a 2.4 the port intakes feed the port cylinders,starboard intake feeds starboard cylinders,on a 2.5 a couple hoses change sides,Chris

[tlwjkw]

i've always "crossed" tha things on both.. don't remember why.. didn't have drawings back then.... learned 'bout "bleeds" with a formula motor which had 12 bibs on front half! was fun for tha first time seein' it......