2.5 7 pedal front half.

[Project7]

I have a 200 ff block that I am looking to put a 7 pedal front half on. Any help on this swap would be great too.

[Asstracker]

Pretty easy swap. has to be a small being though. the 200's (225's/240's) were small bearing and some of the 260's. later 260's and 280's (not sure about drags) were big bearing, won't fit crank. should bolt right up how the 5 pedal came off. gl finding one!!

[FORBESAUTO]

Recommend removing alignment dowels and remove crank ring wear grooves. This will allow the crank to align the half to block in case of casting/machining differences. (Halves are originally matched to mating blocks so very possible not a perfect fit, but crank dimensions should be the same) and prevent crank ring groove mismatch

[Project7]

not needed now