32x15.5 Mad Efi 4 Blade

[L&B]

32x15.5 Mad EFI 4 Blade
$800
305-587-3095

[JPEROG]

Guys with the 21 skaters that are used to running the 32 pro-et....This is your modern day replacement (you will need to take some diameter out or run your motor higher to turn it up).

Joe

[JPEROG]

Sold,

Thanks Julian-

Joe

[Turborr]

Guys with the 21 skaters that are used to running the 32 pro-et....This is your modern day replacement (you will need to take some diameter out or run your motor higher to turn it up).

Joe

So....got my attention here. I have been looking for a Pro ET that is unobtainium these days. I looked at this prop and saw that it was a 15.5 which is an inch over the ET. So are you saying to buy one of these in a 32 and get it cut down an inch? Or maybe can a 30 work just as well? Are these props available new? Are they a copy of the ET with a bigger diameter? This is for a 21 cat.

[JPEROG]

They are not a copy of an ET but do have a very similar blade design. They are a thru hub Vs the Pro-et being an over hub, but they work very well like a Pro-et always has on on heavier hulls. The reason I said you would have to cut it down is simply due to horsepower restrictions "it takes some real torque to put a 15 1/2 dia. four blade into the 6K and up zone without bringing the motor up really high which then pulls blade surface out of the water and lets it rev".