V6 for race car wanted

[Hillclimber]

Hi - For my next project, I am looking for a V6 two stroke with EFI etc AND ability to remove exhaust to expose ports allowing expansion chambers to be used/fitted. Really need 300hp + , 400 better!! to give us 1000hp per 2000lb car weight.

My latest project below with a V8 with 8 Mikuni SBN carbs runs well BUT I have had to use a 180 degree bend onto the original exhaust and then a BIG silencer(Muffler) to get down to the required 108db noise level. The engine "Sounds" strangled if you listen on this video but its still damn fast. Easily beats the Ferraris seen in the pit background.

https://www.facebook.com/peter.hubba...23536888381817

[Merc 2.5]

That's cool as hell if nothin else , I've seen 1 other car on YouTube with v8 omc, but it wasn't fast , what kinda trans setup u got?

Ok I see u said cvt trans , what was it originally out of

[LakeFever]

Cool build. For the expansion chambers it might be best to start with a fishing motor with more meat in exhaust chest so you could mill flat surfaces for mounting the pipe flanges. A good EE V6 merc block sounds appealing. Get the port work matched up to a 300 drag and away you go. Brucato makes nice acu engine controllers for efi mercs that might work well if you dont already have engine management plans.