User Tag List
Thanks: 0
Results 1 to 5 of 5
Thread: 1988 85 Force ignition
-
06-12-2021, 04:00 PM #1
1988 85 Force ignition
Hello friends... I am trying to troubleshoot my friends 85 HP Force outboard. #1 cylinder has no spark. To make matters worse.. I can't remove the flywheel to inspect the stator. Is there something I can check without removing the wheel?
I know you guys are the best! Thanks!
-
06-12-2021, 11:39 PM #2
Could you swap coils and see if it follows?
1990 Shadow bass boat w/ 2.4 200 Merc. Totally resto'd boat and love it!
-
Forkin' Crazy liked this post
-
06-13-2021, 02:30 PM #3
Problem stays with #1 cyl. I got the flywheel off finally! There is a circular type magnet... all the way around... not secured in any way! Stator coils look good but didn't check with meter
-
06-14-2021, 08:08 AM #4
runs on #2 and #3. suspect stator... low resistance on one yellow wire, like 500 Ohm
-
06-14-2021, 08:28 AM #5
Thats one of the worst ing systems on the planet. The cdi boxes work together and will fight each other.Usually you will have to replace both cdi boxes and the stator. Could cost more then the motor is worth.Or find a set of electronics in working order on ebay/fb? Good luck bro you will need it.
I may be slow but im ahead of you. *hit's only ankle deep but you went in head first.
Similar Threads
-
Air Force One? How about BOAT FORCE ONE!!! MAGA!!!
By home made tunnel in forum General Boating DiscussionReplies: 13Last Post: 09-29-2018, 11:10 PM -
1988 2.4L XR4 Fresh rebuild no performance mods! On 1988 Bass Tracker etc. Need Gone!
By AllCarbDiet in forum Outboard EnginesReplies: 0Last Post: 04-07-2016, 08:08 PM -
1988 Baja Force 216 - good boat?
By puzzleboy in forum General Boating DiscussionReplies: 2Last Post: 07-07-2009, 06:11 PM