200 trim ram needed

[Poky]

I had some very bad luck, I had some engine problems out in the middle of the lake. Dropped a socket down the jack plate. Didn't think much of it other than another donation to the lake. But then the trim started leaking. Pulled the trim apart to replace the o-rings. put then found the lost socket. I was between the ram and the transom plate. as you know, there isn't room there for a socket. with the trim down, it cracked the body of the center trim ram. So I need the center trim ram for a 90's 200 EFI 20 inch. Maybe a trim unit with a bad motor? and this is all on a 200 that has just been rebuilt, and I just started breaking it in.

[Schramer]

Assuming it is a 3 ram system and not a single ram?

[Poky]

yep, the center is a ram, I call it three ram, but only the center is a ram.

[Schramer]

I will see what I have available.....as well as some of my friends

[Poky]

Thanks, I'm hitting up all of the shops I know to see anyone has something sitting around. For right now, I swiped the trim off my Pro Max. Not what I really wanted to do, But they are talking 90 this weekend.

[Treeguy]

i have several pm me a phone number

[Poky]

pm sent, also I only need the ram. I'd rather not buy a whole trim unit if I don't need to. Also, my trim sensor fell apart when I took it off. Does any know the part number?

[Schramer]

pm sent, also I only need the ram. I'd rather not buy a whole trim unit if I don't need to. Also, my trim sensor fell apart when I took it off. Does any know the part number?

I found a single ram, that won't help you.....also have a buddy that has what you need but in a complete trim/clamp/swivel/& can so I would look into Treeguy's stock before we go down the road you don't want, nor need to take haha

Schramer

[THP]

PM sent
Troy

[Poky]

I'm very thankful, Got what I needed. Now to get everything back together. Thanks guys