User Tag List
Thanks: 0
Results 1 to 3 of 3
-
05-11-2021, 05:09 PM #1
how to build lighter structures and bulkheads
.
...using foam core and carbon fibre in high load areas..
.
-
-
05-12-2021, 07:51 AM #2Screaming And Flying!
- Join Date
- Jun 2007
- Location
- Singapore/Melbourne/Italy
- Posts
- 9,109
- Thanks (Given)
- 1010
- Thanks (Received)
- 356
- Likes (Given)
- 4327
- Likes (Received)
- 1976
- Mentioned
- 8 Post(s)
- Tagged
- 0 Thread(s)
We need a vid of a racing yacht build to see high tech and big load.
-
noli liked this post
-
05-12-2021, 08:42 AM #3Screaming And Flying!
- Join Date
- Mar 2008
- Location
- Tourist Trap, Florida
- Posts
- 14,753
- Thanks (Given)
- 381
- Thanks (Received)
- 1305
- Likes (Given)
- 5602
- Likes (Received)
- 11033
- Mentioned
- 2 Post(s)
- Tagged
- 1 Thread(s)
All the big cruising cats that have plywood bulkheads are seeing failures.. Not from rot, can't carry the vertical shear loads. Weight kills these types of catamaran. With a broad beam, and high rigging loads pressing down they are very stressed. These guys understand this and are going "over kill" on the construction. Good old foam core, bi ply glass , some carbon and epoxy.
83 V-King, 96 Mariner, 200 hp ff block 2.5 w/a 28p choppa
We gotta clean this liberal mess up, VOTE TRUMP TO MAGA!
Rebuild thread:
http://www.screamandfly.com/showthre...-it&highlight=
http://www.screamandfly.com/showthre...cs.&highlight=
Videos
Similar Threads
-
Replacing Bulkheads in Fiberglass pontoons
By LaveyT in forum Fiberglass and Composites DiscussionReplies: 8Last Post: 12-27-2017, 11:10 PM -
STV EURO trim pump bulkheads fittings
By Brookbbb in forum Props, Setup, and RiggingReplies: 4Last Post: 02-15-2017, 04:36 PM -
filling bolt holes in stv bulkheads
By aggiestckl in forum Fiberglass and Composites DiscussionReplies: 29Last Post: 04-10-2014, 12:40 AM -
Bulkheads what are they
By eddie baird in forum Fiberglass and Composites DiscussionReplies: 12Last Post: 04-21-2010, 04:55 PM -
Help with glassing stringers and bulkheads
By boatless in forum Fiberglass and Composites DiscussionReplies: 1Last Post: 10-18-2004, 07:48 PM