Looking for a cheap mercury power head 135/150/175

**bullet123** · 03-15-2021, 04:13 AM

Looking for a cheap repower for my nephews first bass boat. it can be a bare rotating assembly. 2.0 , 2.4 , or 2.5. thanks

**25two.stroke** · 03-15-2021, 03:55 PM

I have a mostly complete carb 175 2.5l with oil injection. I think all it needs is bleeder lines and hook up the voltage regulators.

It ran fine but was down like 10 psi in one cylinder...so I tore it all apart and the cylinders looked perfect and were round. The pistons looked perfect and so did the rings. I put it all back together with new rings and head gaskets and now the compression is 120 +/- 2 psi in all cylinders. I don't know what caused that initial low reading, maybe my gauge screwed up or the endgap on onw ring was off, not really sure but its good now.

What do you mean by "cheap?" how much you wanna spend? I'm across the country, so it might not make sense for you to pay for the powerhead and shipping. If you are interested I will hook the bleeders and charge system up and run it before it goes out to you. Let me know if you want it as a drop-on or if you just want something cheaper.

**ShadowFlier** · 03-15-2021, 04:42 PM

I have a nice modded 2.0 block and horizontal front half with rods and pistons I'd let go cheap. Like $300 + shipping cheap. Let me know if interested and I can get you some pictures.