User Tag List
Thanks: 0
Likes: 0
Results 1 to 2 of 2
-
03-02-2021, 09:20 PM #1Member
- Join Date
- Nov 2006
- Location
- Sarasota, FL
- Posts
- 45
- Thanks (Given)
- 0
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
OMC Crossflow Lower mount question
Hello Everyone,
Hope everyone is well !!
I read on an older post that using lower mounts from a 150GT, were a good upgrade to the stock mounts?? (regular 1983 Johnson 150).
I hesitate to go full solids because of the extra vibration?? Seems I read the solids create quite a bit more vibration??
I wasn't going to change the upper, is this a mistake. My stock one seems fine..
Any thoughts, suggestions, would be appreciated....
THX...AL'82 Checkmate Diplomat
"83 Johnson 150
best so far: 71mph
'72 Duster340 4spd
'72 Hemi Duster (under construction)
Life is either a daring adventure or nothing!
-
03-11-2021, 07:01 AM #2
You can shim the mounts you have see this thread.
https://www.screamandfly.com/showthr...TOR+MOUNT+SHIMPaul V.
1987 Hydrostream Viper - 1973 V4 Evinrude 135 Crossflow "Shiny Motor"
Similar Threads
-
CCM Reads and blocks/solid upper mount crossflow
By omcforever in forum Misc. Parts and AccessoriesReplies: 6Last Post: 12-21-2020, 11:55 PM -
Need solid upper mount for V4 crossflow
By ChrisCarsonMarine in forum Misc. Parts and AccessoriesReplies: 6Last Post: 10-14-2016, 12:11 PM -
Mercury Tech: Question on Mercury Lower Units: 80' 2.4 200 lower swap to 2001 opti lower
By NoRdO in forum Technical DiscussionReplies: 2Last Post: 08-16-2016, 09:21 PM -
OMC Tech: Lower unit compatability question - Crossflow to Looper
By Steve2ManyBoats in forum Technical DiscussionReplies: 5Last Post: 01-04-2013, 06:44 AM