Hi Folks,

Rigging my boat and going to use a MACH CRT as my steering wheel hub, however the CRT base needs a pin to hold it stationary but the Capilano helm shaft is quite far out from the DASH. Additionally I have been unable to find any Bezel that will cover the Helm mounting bolts and reach to the base of the CRT to allow me to use for the CRT stationary PIN.

I don't have PICs at the moment and I could get a custom spacer made, but I have seen a number of skaters with this steering so was hoping someone else had solved this problem with "orderable" part.

Anyone who has rigged one will immediately understand the problem.

If no one has an obvious solution I'll just get a spacer made but seems like I should be able to buy something
Dave