User Tag List
Results 1 to 2 of 2
Thread: Torque tab size??
-
01-13-2021, 08:48 AM #1
Torque tab size??
Getting close to having the nose cone job finished on my lower. I welded on a piece of aluminum for a torque tab and have been fairing it out with the Bob's epoxy that came with the cone kit. I think right now its probably too big, I just don't know how far to cut it down.
Case is a 2:1 preload if it makes a difference.
What is an approximate size for a torque tab?
Currently it extends beyond the rear of the skeg about 7/16" and rises about 3/8" off the starboard side. Hope that explanation makes sense, pictures below.'78 Hydrostream Viking/'98 225 ProMax
Restoration: https://www.screamandfly.com/showthr...Viking-rebuild
Pictures: https://www.flickr.com/photos/152974...57708863869223
Videos: https://www.youtube.com/tnels
-
coffeeguy thanked for this post
-
01-13-2021, 10:29 AM #26000 RPM
- Join Date
- Feb 2011
- Location
- HUDSON, FLORIDA
- Posts
- 1,529
- Thanks (Given)
- 431
- Thanks (Received)
- 64
- Likes (Given)
- 434
- Likes (Received)
- 452
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
-
tnelsmn liked this post
Similar Threads
-
Mercury Tech: Tilt tube Zerk fitting size and thread size??
By Sheer Insanity in forum Technical DiscussionReplies: 1Last Post: 07-25-2012, 09:12 AM -
How much torque tab and how (already have a TH marine torque tamer)
By Mr. Demeanor in forum Props, Setup, and RiggingReplies: 15Last Post: 10-04-2010, 08:51 PM -
jet size
By dangerou1944 in forum Technical DiscussionReplies: 0Last Post: 08-26-2006, 02:51 AM -
Pic Size
By G-Train in forum General Boating DiscussionReplies: 17Last Post: 06-10-2002, 08:50 AM -
Location, size, and size of
By popeyebob in forum Technical DiscussionReplies: 4Last Post: 09-03-2001, 01:19 PM