Smart craft 100 mph speedo

[2.5-21]

Looks like the part number you listed has 16 pin.... Might be for a Vessel View, Do you have a Rigging parts catalog?

[25two.stroke]

Looks like the part number you listed has 16 pin.... Might be for a Vessel View, Do you have a Rigging parts catalog?

Darn, sorry. They do make the cable you need, I just gotta find it. Yes I have a rigging parts catalogue. And I have some old ones too, back to like 2007 I think. Its in one of them. I am going by the shop in a few hours I will dig.

I know I told some other people I would look for stuff at the shop too but I keep on forgetting who I told what...I will make a list

[25two.stroke]

So I failed. I looked everywhere in all the books for like an hour with my coworker trying to find your p/n. It is a vesselview harness but it does not appear they sell it separate. You would have to get a complete vesselview kit just for that harness. Thats silly cause they sell every other harness independently, but I just cannot find that one. I found drawings of it in the smartcraft tech/design guide, but no part numbers. Its crazy. They show two different 10 to 14 pin harnesses, one with a NMEA 200 pigtail (newer) and one without).

[2.5-21]

Thanks for the effort..... Do you know the part number for each picture? Top and bottom?

[25two.stroke]

Thanks for the effort..... Do you know the part number for each picture? Top and bottom?

No. Thats what I was trying to figure out! Thats the harness that you need, but in the design book they don't list p/ns

[2.5-21]

No. Thats what I was trying to figure out! Thats the harness that you need, but in the design book they don't list p/ns

This part is available I think I will order it....84-8M0055076
Are you a parts dealer?

[25two.stroke]

This part is available I think I will order it....84-8M0055076
Are you a parts dealer?

I work for a dealer, yes. But I can't get it any faster than any other merc dealer...