20 inch 2L merc with CLE on 25 inch transom

[David]

You can run a sport master on your boat and nothing bad will happen. It might not be the fastest option but so what. Your boat will be a lot faster than with the 115

[killerpirate]

Thanks David, thats exactly what i needed to hear

[killerpirate]

This morning i went to visit the owner of the motor. What do you all think? Looks very clean under the cowling, but a couple of things are missing:
Temperature switch on the left cylinder bank (is it supposed to be there?)
Throttle linkage between carbs
Also the brown small hoses are very hard, not bendable

[Dave Strong]

Port side sender is for temp gauge, stbd is for overheat alarm. Bleed lines are easy to replace, if they are bad chances are the one between upper and lower crank bearings also needs replacing.

Dave

[killerpirate]

Thanks for your help Dave!
I noticed this when i spun the prop by hand, makes a little biy more noise then im used, or maybe there is no oil in the LU? It has been sittiny for 2 years
https://youtu.be/DultX6F72nM

[Dave Strong]

Thanks for your help Dave!
I noticed this when i spun the prop by hand, makes a little biy more noise then im used, or maybe there is no oil in the LU? It has been sittiny for 2 years
https://youtu.be/DultX6F72nM

Does not sound great, would not run it like that.

Dave

[tlwjkw]

may be jus cause i'm old and don't remember for sure but don't think tha "only" xr2 i had had a drilled oiler boss???..

[killerpirate]

Does not sound great, would not run it like that.

Dave

Owner told me its probably because there is no oil in the LU (he didnt run it since he bought it)

[Dave S]

Might be the shifter is just off and the dog is touching the gear......You should buy it.....cause there are not many in your area. JMO