User Tag List
Results 1 to 15 of 16
-
11-20-2020, 07:32 PM #1Member
- Join Date
- May 2016
- Location
- Upper Potomac River
- Posts
- 71
- Thanks (Given)
- 1
- Thanks (Received)
- 5
- Likes (Given)
- 4
- Likes (Received)
- 9
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Feeler: WTB Merc 2.5 200 complete outboard 20"
Hey,
Just throwing it out there... I'm looking to buy a 200 2.5, preferably FF block, complete outboard w/20" mid.
Located in the Washington D.C. area, willing to travel some.
Let me know what you got...
Thanks
-
11-20-2020, 10:13 PM #2Member
- Join Date
- May 2016
- Location
- Upper Potomac River
- Posts
- 71
- Thanks (Given)
- 1
- Thanks (Received)
- 5
- Likes (Given)
- 4
- Likes (Received)
- 9
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Also willing to entertain one that's down a cylinder so long as the block is ok....
-
11-20-2020, 10:29 PM #3
-
11-22-2020, 12:06 AM #45000 RPM
- Join Date
- Oct 2017
- Location
- Nacogdoches, Tx
- Posts
- 200
- Thanks (Given)
- 5
- Thanks (Received)
- 3
- Likes (Given)
- 15
- Likes (Received)
- 21
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I have a mid and lower if OP wants to piece a motor together.
-
11-22-2020, 07:05 AM #55000 RPM
- Join Date
- Jan 2008
- Location
- SUMMERVILLE S.C.
- Posts
- 201
- Thanks (Given)
- 1
- Thanks (Received)
- 34
- Likes (Given)
- 8
- Likes (Received)
- 42
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I have a 200 efi Mag Mariner
-
11-22-2020, 07:55 AM #6Screaming And Flying!
- Join Date
- Jul 2004
- Location
- Connecticut
- Posts
- 6,009
- Thanks (Given)
- 465
- Thanks (Received)
- 168
- Likes (Given)
- 911
- Likes (Received)
- 951
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
.........
I have a very clean black XR-4 lower with torque tab and coned lwp if that makes any sense for the puzzle pieces.
-
NoRdO liked this post
-
11-23-2020, 12:16 PM #7Member
- Join Date
- May 2016
- Location
- Upper Potomac River
- Posts
- 71
- Thanks (Given)
- 1
- Thanks (Received)
- 5
- Likes (Given)
- 4
- Likes (Received)
- 9
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Greg G, What are you looking to get for the x4 lower? That is the smaller diameter one right?
-
11-23-2020, 12:21 PM #8Screaming And Flying!
- Join Date
- Jul 2004
- Location
- Connecticut
- Posts
- 6,009
- Thanks (Given)
- 465
- Thanks (Received)
- 168
- Likes (Given)
- 911
- Likes (Received)
- 951
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
No, it is not the smaller. Internals are almost new though. I believe the XR6 was the small diameter but someone will confirm if that is correct.
-
11-23-2020, 03:23 PM #9
xr4s were ALL small (as my understanding. Mercury did do odd stuf and I'm sure someone will say I'm wrong). xr6s came in 2 sizes: the small (4 1/4 and the standard 4 3/4).
The xr4 small and the xr6 small were different though, the xr6 small was srtonger. Someone else can comment on this though.
The xr6 is preferred for drag racing around here but none of the small ones can last long runs unless they are extensively worked out IMO8' Yellow Jacket - 25 hp Mariner
1984 Hst VKing - 15" Bridgeport EFI
1990 Collins Mirage - 15" 260
22' Aquasport - 150 SeaPro Fourstroke
25 hp Merc that runs on ACETONE
25 hp Merc with dry side pipe
25 hp Merc with 11" mid and 2.42:1 gears
-
Greg G thanked for this postTEXAS20225 liked this post
-
11-23-2020, 03:23 PM #10
It looks like the small case compared to the CLE in the pic
8' Yellow Jacket - 25 hp Mariner
1984 Hst VKing - 15" Bridgeport EFI
1990 Collins Mirage - 15" 260
22' Aquasport - 150 SeaPro Fourstroke
25 hp Merc that runs on ACETONE
25 hp Merc with dry side pipe
25 hp Merc with 11" mid and 2.42:1 gears
-
11-23-2020, 04:12 PM #11Member
- Join Date
- May 2016
- Location
- Upper Potomac River
- Posts
- 71
- Thanks (Given)
- 1
- Thanks (Received)
- 5
- Likes (Given)
- 4
- Likes (Received)
- 9
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Wouldn't the small case be fine for recreational use on a 15' viper? I do typically do long WOT runs, sometimes as long as 10 miles... This would of course be with a stock 2.5 200 powerhead...
-
11-23-2020, 04:27 PM #12
I should defer that to people who have run them a lot personally, I have not. I do know, however, that they are liked in the bass boat world and I have seen many XR4s come into the shop where I work that have hundreds of hours on the stock gearcase. I am personally lookin for one to try out, I don't think they are as bad as some people make them seem (but I want to try for myself).
But they do have less oil in them and run a little warmer. I know there is someone around who cuts sportmaster gears down to fit in this dia. case. Not sure if anyone makes the billet cariers and such to put in though.8' Yellow Jacket - 25 hp Mariner
1984 Hst VKing - 15" Bridgeport EFI
1990 Collins Mirage - 15" 260
22' Aquasport - 150 SeaPro Fourstroke
25 hp Merc that runs on ACETONE
25 hp Merc with dry side pipe
25 hp Merc with 11" mid and 2.42:1 gears
-
12-03-2020, 10:58 AM #135000 RPM
- Join Date
- Apr 2017
- Location
- Pomona ny
- Posts
- 251
- Thanks (Given)
- 2
- Thanks (Received)
- 12
- Likes (Given)
- 4
- Likes (Received)
- 48
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Last edited by Duro78; 12-03-2020 at 11:03 AM.
-
12-04-2020, 08:09 AM #145000 RPM
- Join Date
- Sep 2017
- Location
- Collingwood Ont. Canada
- Posts
- 318
- Thanks (Given)
- 35
- Thanks (Received)
- 11
- Likes (Given)
- 91
- Likes (Received)
- 51
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
-
12-04-2020, 09:16 AM #15Junior Member
- Join Date
- Dec 2010
- Location
- Augusta, Ga
- Posts
- 13
- Thanks (Given)
- 0
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 1
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
If you could please provide some additional details of the Mariner and possibly photo's I have interest. Thanks!
Similar Threads
-
1992 merc 2.5 260 complete outboard
By JHERAMBJR in forum Outboard EnginesReplies: 3Last Post: 02-20-2017, 06:05 PM -
2.5 200 complete motor - feeler
By wing nut in forum Outboard EnginesReplies: 12Last Post: 03-02-2016, 08:17 PM -
"Feeler tread" Saint lucie locks to Clewiston run June 30
By chris-miami in forum General Boating DiscussionReplies: 14Last Post: 06-21-2012, 09:03 PM -
Feeler for the return of "RUMBLE ON THE RIVER 2011", Carrolton KY.
By Liberator*21 in forum General Boating DiscussionReplies: 95Last Post: 07-20-2011, 10:26 AM