33C cable end, eyes

[Instigator]

Need the small screw on (10-32 female thread) eye for the end of the cables and mounts to 3/16” pins.

These are for my Keikhaefer racing controls in my twin OB Convincor project.
They actually use a small hook at that end but are unobtanium and stupid expensive if so.

I can make these eyes work but can’t find them.

listed as: Seastar Solutions #301072

Found two for $11 per but sure on source.

Need four of them.

They make plastic ones that are too fat and alum that are also too big and the pin hole too large.

Thx guys!

Gary

[Instigator]

This is what I’m looking for.

[FUJIMO]

...so, you already have slotted cables simular to these, i take it...now you just need the ends...

[FUJIMO]

...what you ideally want to use are the proper kiekhaefer/mercury hooks, part #845281. those seastar/teleflex/morse ends you want are'nt always the correct length & are part of their cable end kits. you would need two of they're kits. yes, they are not cheap either. believe those kit part numbers were 301901, or the other kit number 301074. but if you have used them in the past & those ends worked for you, so be it. try to track down 4 of the hooks first.

[FUJIMO]

[FUJIMO]

[Instigator]

Yep, that’s it.
And yes to those cables.

I read on OSO that a guy made my style work.

Thanks though, as I couldn’t even find that part #.

Had the same set up in my old Sonic but the came w/the Clevis ends.

[FUJIMO]

...seastar solutions also used to offer these, part number 317413, in aluminum...10-32 threads with a 5/16 eye hole...

[FUJIMO]

...or in red, part number 300646...

[FUJIMO]

[FUJIMO]

www.cccables.com

[Instigator]

The eye hole needs to be .185”, 3/16”.

The plastic ones are too thick too. I have several from different adapter kits.

I found four of the real ones on e-bay.
$17 per and on their way.

Thx again for your help.

[FUJIMO]

...good. yeah, that was/is the best way to go. and don't go loosing those damn things! lol