User Tag List
Thanks: 0
Likes: 0
Results 1 to 2 of 2
-
07-14-2020, 10:45 PM #1Junior Member
- Join Date
- Jun 2019
- Location
- NW Indiana
- Posts
- 21
- Thanks (Given)
- 2
- Thanks (Received)
- 1
- Likes (Given)
- 8
- Likes (Received)
- 4
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
merc inline 6 1150 trim pump rebuild
Merc 1150 inline 6 SN 641xxx, with an in boat trim pump.
I noticed my trim pump was smoking when in use so i decided to take it apart and found some serious issues. The brushes are completely gone and have worn a large groove into the commutator, not to mention caused a large amount of debris within the motor itself.
I would like to rebuild it with new parts but am a bit confused by the parts diagram if anyone has any experience with these trim motors.
When looking at pictures of new parts, the cap (392-8262) has two brushes and field/frame assembly(392-8261) also appears to have a brush attached to it. Looking at my motor it appears only one brush from the cap is used and the other comes from the frame. Is this the correct setup to follow?
Thanks for any info
-
07-15-2020, 05:53 AM #2Screaming And Flying!
- Join Date
- Dec 2001
- Posts
- 9,502
- Thanks (Given)
- 23
- Thanks (Received)
- 271
- Likes (Given)
- 191
- Likes (Received)
- 1976
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I have lots of used ones......cheep ….save your self lots of work...…..
Similar Threads
-
Need merc inline 6 trim pump
By hydrovector77 in forum Misc. Parts and AccessoriesReplies: 3Last Post: 07-29-2014, 07:59 AM -
I need help rigging a Merc 1150 inline-6 to a V-King
By IWannaGoFaster in forum Props, Setup, and RiggingReplies: 12Last Post: 08-11-2005, 04:21 AM