WTB stock 150-225 2 stroke Carb Merc motor

[Liberator*21]

NO LONGER LOOKING, THX

Just bought a Bass Boat again and looking to replace the current under powered Yamaha motor with a (FRESH WATER) turn key Merc 2 stroke carb motor. Carb motor preferred but open to an EFI. Looking to see what's out there......

Thanks

[tunnelmike]

I've got a 95 mag 3 150 powerhead on a 91 mid and lower $1800. Clean freshwater motor but it's in Mississippi

[tunnelmike]

[Liberator*21]

Good looking motor, 20" mid I assume? Pics under the hood, compression #'s, lower gear ratio, etc.......

[25two.stroke]

I've got a '85 200 carb 2.4 in real good shape...see the following thread: https://www.screamandfly.com/showthr...-oil-injection

[tunnelmike]

1:87-1. I'm working out of town till next Saturday most likely. Only pic I have on my phone. Compression was even at 125 when I got the powerhead. Six01-551-1350. Thanks Mike

[Liberator*21]

1:87-1. I'm working out of town till next Saturday most likely. Only pic I have on my phone. Compression was even at 125 when I got the powerhead. Six01-551-1350. Thanks Mike

Hi Mike, I'd like to talk to you on the motor. Give me a good time to call so we can talk a little.

Regards,
Gary

[tunnelmike]

Usually after 7pm central time we are wrapped up for the day. Working 12's to try and get done as quick as possible. Talk this evening. Thanks Mike

[Liberator*21]

Usually after 7pm central time we are wrapped up for the day. Working 12's to try and get done as quick as possible. Talk this evening. Thanks Mike

I'll dial you up about 7:30 Central Time

Thank you

[Liberator*21]

Mike, forgot to ask if it had the 4.75 dia. gear case ?

[tunnelmike]

Standard size case. I'd have to check the diameter. It's not the small xr6 case.

[Liberator*21]

Standard size case. I'd have to check the diameter. It's not the small xr6 case.

Thanks Mike, let me know later.