User Tag List
Thanks: 0
Results 1 to 6 of 6
-
07-09-2020, 11:39 AM #1Member
- Join Date
- Jan 2019
- Location
- SC
- Posts
- 58
- Thanks (Given)
- 0
- Thanks (Received)
- 0
- Likes (Given)
- 1
- Likes (Received)
- 2
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
timeing on 2.5 with exhaust boster ports
Have a 2.5 fresh build 36cc heads compresson is 140psi seams a little high for a boster port exhaust. checked with two gauges. What is max timeing?
-
07-09-2020, 11:59 AM #2
24-25 degrees
Team Junk
No sparkling wiggles in here, only dump truck grinches.
"Screamin Heathen"
-
07-09-2020, 12:19 PM #3Member
- Join Date
- Jan 2019
- Location
- SC
- Posts
- 58
- Thanks (Given)
- 0
- Thanks (Received)
- 0
- Likes (Given)
- 1
- Likes (Received)
- 2
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Thanks, sounds good,just wanted to make sure.
-
07-09-2020, 12:35 PM #4
If ya gonna run it to 24-25, I’d index flywheel on all six cylinders and check all cylinders and set it to highest running cylinder, almost always another cylinder is a little higher than #1. If not, I’d run it 22-23. JMO. There is a handful of threads telling how to index flywheel, if ya don’t already know how
-
rock liked this post
-
07-09-2020, 12:46 PM #5
Good advice.
RockTeam Junk
No sparkling wiggles in here, only dump truck grinches.
"Screamin Heathen"
-
07-09-2020, 01:47 PM #6Member
- Join Date
- Jan 2019
- Location
- SC
- Posts
- 58
- Thanks (Given)
- 0
- Thanks (Received)
- 0
- Likes (Given)
- 1
- Likes (Received)
- 2
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
all ready index and checked. TKS
-
FORBESAUTO liked this post
Similar Threads
-
Oil coming out of exhaust ports
By 007joe in forum Technical DiscussionReplies: 13Last Post: 08-19-2014, 09:13 AM -
Inline exhaust ports
By spongebob440 in forum Technical DiscussionReplies: 11Last Post: 02-25-2011, 10:13 AM -
2.4 exhaust ports are smaller then 2.0
By camaro7081 in forum Technical DiscussionReplies: 1Last Post: 04-08-2006, 02:21 PM -
Optimal Exhaust Ports
By bishopg in forum Technical DiscussionReplies: 14Last Post: 03-02-2005, 02:55 PM