300xs oil line connections

[team supra]

Could someone please tell me how to connect the two oil lines from remote tank to motor? I believe blue line hose goes to tee, the other says it connects to crankcase valve, but can’t find it

[XstreamVking]

Blue is supposed to be the oil feed line going to tee. . Black goes to a hose nipple fitting under the starter area, low on the star side of block.
They do get crossed at the tank by techs sometimes, so you can pop off the tank cap and see which one goes where if you need to.

[team supra]

Thanks guess I was looking at wrong side of block

[XstreamVking]

When you get it fired up on the hose, loosen the cap on the motors oil tank. The oil from the boats tank should start to flow after a minute and fill/spill out of the engines tank. Close cap (gently) and check for leaks.

[team supra]

Thanks again . Manual tells how to do somethings but not how or where to make connections, like battery leads, shows you how to put them on battery but not motor

[team supra]

Thanks, manual does not tell you much on installation, not even where to hook up battery cables on motor just on battery,
pretty silly

[XstreamVking]

Is this a new, never operated engine? If so the oil pump will need to be primed before it is run.....VERY IMPORTANT!!!!!!