User Tag List

Results 1 to 4 of 4
  1. #1
    Join Date
    Feb 2020
    Location
    Hazlehurst georgia
    Posts
    20
    Thanks (Given)
    0
    Thanks (Received)
    0
    Likes (Given)
    0
    Likes (Received)
    3
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Wtb 15" cle driveshaft

    Looking for a 15" driveshaft for 1997 2.5 cle lower

  2. #2
    Join Date
    Oct 2004
    Location
    FL
    Posts
    8,835
    Thanks (Given)
    416
    Thanks (Received)
    420
    Likes (Given)
    5900
    Likes (Received)
    2460
    Mentioned
    2 Post(s)
    Tagged
    1 Thread(s)
    I have 3- 15"
    1- New Stainless installed but never ran and swapped for 20”
    1- Good used and clean HiPerf.
    1- Good and used HiPerf single bearing.
    2- are double bearing so you would need to put spacer for the second bearing since CLE’s are single bearing.

    Any $450 shipped & insured.


    Tony
    516 807-1456

  3. Likes Frank Molé, Ace liked this post
  4. #3
    Join Date
    Jun 2006
    Location
    Ramona Ca
    Posts
    270
    Thanks (Given)
    1
    Thanks (Received)
    0
    Likes (Given)
    1
    Likes (Received)
    6
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Are these the same as the sport master drive shafts?

  5. #4
    Join Date
    Oct 2004
    Location
    FL
    Posts
    8,835
    Thanks (Given)
    416
    Thanks (Received)
    420
    Likes (Given)
    5900
    Likes (Received)
    2460
    Mentioned
    2 Post(s)
    Tagged
    1 Thread(s)
    Quote Originally Posted by 67racing View Post
    Are these the same as the sport master drive shafts?
    Yes, the 2 with double bearing are. Sportmaster use 2 bearings.
    1- is a Mercury stainless cut and resplendent and the other is a Hi-Perf 20" that was cut to 15".

Similar Threads

  1. 5" Driveshaft Extension. Converting 20" Lower Unit to 25"
    By bigshrimpin in forum Technical Discussion
    Replies: 13
    Last Post: 01-27-2020, 10:45 AM
  2. Replies: 3
    Last Post: 05-05-2014, 12:18 PM
  3. OMC Tech: thoughts on the "generic" sierra marine driveshaft shimming tool?
    By pcrussell50 in forum Technical Discussion
    Replies: 4
    Last Post: 07-19-2011, 09:14 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •