User Tag List
Thanks: 0
Likes: 0
Results 1 to 2 of 2
Thread: testing CDM procedure question
-
05-14-2020, 07:10 PM #1Junior Member
- Join Date
- Apr 2018
- Location
- Niagara Falls
- Posts
- 8
- Thanks (Given)
- 4
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
testing CDM procedure question
I am trying to test the CDM,s for my 2000 200EFI using the mercury manual, but i am a little confused by the procedure. the page shows the CDM but it isnt specified if i am testing the coil leads with or witout the the wiring harness hooked up to it?
is it a "must" that i have the CDM test harness for this procedure?
and im also assuming that my KLIEN digital meter isnt going to work; i need an analog DVA meter (or a dva adapter)?
after fooling around, im guessing i need the test harness, the harness connected and i need a DVA meter...
Karl
-
05-15-2020, 10:03 AM #2Junior Member
- Join Date
- Apr 2018
- Location
- Niagara Falls
- Posts
- 8
- Thanks (Given)
- 4
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Also, for those who are pro’s; Instead of paying $80 for a harness, can I simply make an extension with the test leads?
i ordered a meter and harness, along with the merc flywheel puller
Also found the wires on the trigger were deteriorating so ordered a new one. I clean the engine compartment a few times a year to inspect wires and connections but until now the coating appreared to be ok, it’s falling off and wires are green and also coming apart.Last edited by KZaker; 05-15-2020 at 12:04 PM.
Similar Threads
-
I'm not getting the warning horn test beep. Question about testing horn.
By Bumblebeeman in forum Technical DiscussionReplies: 4Last Post: 04-03-2020, 10:51 AM -
Video: CRT Testing Stock F1 today! Testing modified F1 on Saturday!
By caldwellrace in forum General Boating DiscussionReplies: 15Last Post: 03-26-2020, 01:11 PM -
Break-in procedure
By 2fast4mom in forum Technical DiscussionReplies: 4Last Post: 01-25-2004, 11:43 AM -
Starting Procedure Question
By Carter Powell in forum Technical DiscussionReplies: 2Last Post: 09-30-2003, 09:37 PM