User Tag List
Thanks: 0
Likes: 0
Results 1 to 8 of 8
Thread: Exhaust Plates
-
03-29-2020, 05:57 PM #15000 RPM
- Join Date
- Oct 2008
- Location
- Tampa, Florida
- Posts
- 165
- Thanks (Given)
- 0
- Thanks (Received)
- 3
- Likes (Given)
- 0
- Likes (Received)
- 4
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Exhaust Plates
Are the same year of 300 X exhaust plate interchangeable with that of an 300 XS? Thank you for any insight...
24' Lorequin, Carson Prepped 250 EFI
-
03-29-2020, 06:15 PM #2
XS motors have a port drilled for a cooling line for the compressor.
-
03-29-2020, 06:21 PM #35000 RPM
- Join Date
- Oct 2008
- Location
- Tampa, Florida
- Posts
- 165
- Thanks (Given)
- 0
- Thanks (Received)
- 3
- Likes (Given)
- 0
- Likes (Received)
- 4
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I have an X mid with a bad exhaust plate and have a chance to purchase an XS plate to put on it. Would this port be an issue? Could I fill it?
24' Lorequin, Carson Prepped 250 EFI
-
03-29-2020, 06:35 PM #4
Just put a pipe plug in it.
-
03-29-2020, 06:59 PM #55000 RPM
- Join Date
- Oct 2008
- Location
- Tampa, Florida
- Posts
- 165
- Thanks (Given)
- 0
- Thanks (Received)
- 3
- Likes (Given)
- 0
- Likes (Received)
- 4
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Thank you Capt.
24' Lorequin, Carson Prepped 250 EFI
-
03-29-2020, 11:03 PM #6
-
03-30-2020, 06:05 AM #75000 RPM
- Join Date
- Oct 2008
- Location
- Tampa, Florida
- Posts
- 165
- Thanks (Given)
- 0
- Thanks (Received)
- 3
- Likes (Given)
- 0
- Likes (Received)
- 4
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Mr. Chaz, the gentleman I purchased the mid from apparently had some trouble removing the block and studs. There is multiple holes drilled where each stud passes through the exhaust plate as well as a small portion of the lip where the lower skirt sits was broken during this as well. Sam
24' Lorequin, Carson Prepped 250 EFI
-
03-30-2020, 08:33 AM #8
I see , they used the "bigger hammer" principle ...
Thank you for the response ..
Similar Threads
-
WTB 20 Inch 2.5L Promax Exhaust Plates (Both upper and lower plates)
By David L in forum Parts WantedReplies: 2Last Post: 03-26-2020, 06:55 PM -
3.0 Exhaust Plates
By aalbert in forum Technical DiscussionReplies: 0Last Post: 02-20-2004, 03:51 PM