User Tag List
Results 16 to 22 of 22
Thread: Power head Studs
-
03-26-2020, 01:09 PM #16
So like onboard nitrous???
Or not necessarily...lol1990 Shadow bass boat w/ 2.4 200 Merc. Totally resto'd boat and love it!
-
04-20-2020, 09:29 AM #17Junior Member
- Join Date
- Aug 2019
- Location
- Butler, PA
- Posts
- 7
- Thanks (Given)
- 0
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Does anyone torque the studs in the block, or do you just snug the studs, and torque the nuts?
-
04-20-2020, 09:38 AM #18The Historic Photo Master
- Join Date
- Jan 2004
- Location
- Florida
- Posts
- 37,836
- Thanks (Given)
- 64
- Thanks (Received)
- 1667
- Likes (Given)
- 337
- Likes (Received)
- 19216
- Mentioned
- 3 Post(s)
- Tagged
- 0 Thread(s)
I've always snugged my stud(s) & nuts...
-
04-20-2020, 10:47 AM #19
Finger tight with grease. The resistance of the nylock nut will seat the stud with enough pressure to stay in place when you go to take the nut back off again, but not so much that the shoulder will dink the top thread ...
-
04-20-2020, 10:52 AM #20Junior Member
- Join Date
- Aug 2019
- Location
- Butler, PA
- Posts
- 7
- Thanks (Given)
- 0
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Good point about the stud shoulder damaging the top threads.
-
04-20-2020, 07:08 PM #21
I red loctite the studs in the block and torque to 25 ft/lbs. The four short studs and threads in the block around the exhaust chest I clean with MEK thoroughly more so than the others because they are a complete ****er if the studs back out of the block. Also I thread the blind hole studs to bottom out in the bosses.
Last edited by Capt.Insane-o; 04-20-2020 at 07:12 PM.
-
04-20-2020, 09:03 PM #22The Historic Photo Master
- Join Date
- Jan 2004
- Location
- Florida
- Posts
- 37,836
- Thanks (Given)
- 64
- Thanks (Received)
- 1667
- Likes (Given)
- 337
- Likes (Received)
- 19216
- Mentioned
- 3 Post(s)
- Tagged
- 0 Thread(s)
Similar Threads
-
power head studs
By Deacon in forum Technical DiscussionReplies: 2Last Post: 12-10-2008, 10:21 AM