User Tag List

Thanks Thanks:  0
Likes Likes:  0
Results 1 to 4 of 4
  1. #1
    Join Date
    Jul 2018
    Location
    Wi
    Posts
    4
    Thanks (Given)
    0
    Thanks (Received)
    0
    Likes (Given)
    0
    Likes (Received)
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    OMC RAker Prop fitment

    Found a Raker 394756 in the garage. What's this fit? Its 15 spline....any help is appreciated

  2. #2
    Join Date
    Apr 2001
    Location
    Windsor, Ontario
    Posts
    5,633
    Thanks (Given)
    0
    Thanks (Received)
    61
    Likes (Given)
    3
    Likes (Received)
    232
    Mentioned
    1 Post(s)
    Tagged
    0 Thread(s)
    It's a 26" Raker and it will fit any random V6 pre Gen II engine. It might fit the Gen II's as well but I don't know.

  3. #3
    Join Date
    May 2001
    Location
    Mooresville NC
    Posts
    5,301
    Thanks (Given)
    10
    Thanks (Received)
    163
    Likes (Given)
    73
    Likes (Received)
    266
    Mentioned
    2 Post(s)
    Tagged
    1 Thread(s)
    Will not fit gen 2. Also needs different thrust washer on 92 up as slightly larger prop shaft right before taper.

  4. #4
    Join Date
    Jul 2018
    Location
    Wi
    Posts
    4
    Thanks (Given)
    0
    Thanks (Received)
    0
    Likes (Given)
    0
    Likes (Received)
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    ok. thanks guys
    Last edited by Snickers89; 11-24-2019 at 12:35 PM.

Similar Threads

  1. omc raker 2 prop
    By Richard in forum Technical Discussion
    Replies: 4
    Last Post: 09-14-2011, 04:51 PM
  2. Raker Prop
    By hoodooguru in forum Props, Setup, and Rigging
    Replies: 3
    Last Post: 07-17-2011, 07:52 PM
  3. E-TEC v4 prop fitment question
    By pcrussell50 in forum General Boating Discussion
    Replies: 1
    Last Post: 07-10-2011, 07:23 PM
  4. OMC Tech: What's the difference Raker & Raker II? Prop
    By decoy033 in forum Technical Discussion
    Replies: 3
    Last Post: 05-17-2010, 04:30 AM
  5. OMC Cobra - V6 Crossflow prop fitment
    By Steve2ManyBoats in forum Technical Discussion
    Replies: 1
    Last Post: 01-30-2007, 11:19 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Eddie Marine - Horizontal